Related Questions

• Which of the following commands removes frame relay encapsulation from an interface?
• The command “show frame-relay pvc” is issued on the Frame Relay Switch to obtain statistics about all PVCs on all frame Relay interfaces. The results display that, one PVC is in DELETED status. What is true about this result?
• You are tasked to configure a router connected to a Frame Relay switch which is configured with ITU-T standard. It is required that you manually configure the LMI type on that interface, hence, disabling the default auto-sensing feature on that router. Which command should satisfy the requirements?
• To display the mapping of layer 3 remote address to a local DLCI number, use the following command:
• Point-to-point frame-relay subinterface in a hub-and-spoke topology requires only one subnet which means it violates the split horizon rule.
• What is the command "show frame-relay map" used for?
• R1 receives a Frame Relay frame from R2 with DLCI value 100 in it. Which of the following statements is the most accurate?
• Refer to the exhibit. Three routers are connected via Frame Relay switch. Each dotted line represents a subinterface. Considering the implemented IP addressing scheme, what type of Frame Relay subinterface must be enabled on the each interface?
• Refer to the exhibit. The command “show frame-relay pvc 101” has been issued on Frame Relay Switch “FRSW”, what is true about its result?
• Three routers; BR1, BR2, and HQ are soon to be connected to a frame relay switch. It is required that the router HQ serves as the main site router which terminates the branch routers BR1 and BR2, so any packets coming from these branch routers is forwarded to router HQ before forwarding to the specific destination. What type of topology should be implemented to satisfy the requirements?