Related Questions

• Refer to the exhibit. What security risks can be found on the configuration shown for Router : R1 ? (Choose Four)
• Refer to the exhibit. A new router (R4) is soon to be added to the existing network, and part of the implementation plan is that traffic from the existing network should not be inadvertently discarded, that is, all traffic from the existing network that is destined to an unknown network be directed to R4. Also, to reduce high processor utilization, R3 should not generate ARP requests for each destination address it sends through the default route. From R3, which one line command statement could be issued to satisfy the goal?
• Your network has no pre-existing ACLs. You, then, decided to input a single ACL entry to deny a single host from accessing the web server. However, you noticed that all packets are being blocked. What should be done to fix the problem?
• You are the network administrator for your company. You want to implement an ACL that uses a centralized device such RADIUS server for the authentication process. What type of ACL should you use?
• A network administrator wants to verify the configured ACLs on a router. What ACL verification command can be used to show ALL IP and IPX access list entries?
• Which statements are true about the command “ip route 172.16.10.0 255.255.255.0 172.16.10.2”? (Choose Two).
• Which of the following interface level ACL commands can be used to immediately remove the effect of configured outbound ACL 100?
• A host is having problem to send data to a remote Server. It is believed that there is a problem with the destination address configured on the host. Which of the following destination addresses must be checked on the host to find the possible root cause? (Choose two)
• Refer to the exhibit. You need to filter any web access from host PC0 of 192.168.1.0/24 network to the "www.skillset.com" website located on the remote network 172.16.0.0/24. What type of ACL should you apply on R1?
• Refer to the exhibit. The network has been configured without routing protocols and the link between router R1 and R2 is fully operational. The script line below is set on Router R1. What is the behavior of Router R1 if the interface f0/1 on Router R2 is shut down?