Skillset can help you prepare! Sign up for your free Skillset account and take the first steps towards your certification.
Refer to the exhibit. The following configuration script has been pasted into the L2 Switch "SW1", intended to enable remote management to the switch. However a Telnet session could not be established from a remote host. What change is needed on the configuration to fix the issue?
The keyword "local" must be added to the "login" command.
The command "line vty" must be changed to "line con".
An IP route to 192.168.254.1 must be added.
The interface vlan 1 must be reconfigured with a physical interface.
"ip default-gateway" ip must be changed to 192.168.254.9.
A L2 switch cannot route packets, any IP outside the local subnet will not be reached without the help of a router. Therefore, the L2 switch cannot be configured with IP addresses in its physical interfaces. To remote manage a router, the logical "interface vlan" must be used. The IP default gateway, in this case, is in another subnet than the interface. The network 192.168.254.8/29 has 6 usable IP addresses. The first is 192.168.254.9 and the last is 192.168.254.14. The IP address 192.168.254.1 belongs to a different subnet.
Study thousands of practice questions that organized by skills and ranked by difficulty.
Create a tailored training plan based on the knowledge you already possess.
Know when you’re ready for the high-stakes exam. Have the confidence that you will pass on your first attempt.