Related Questions

• Refer to the exhibit. You want to configure static PAT on Router1 so that hosts on the LAN while hidden to the internet are able to communicate with public hosts such as web servers like www.skillset.com. Which two of the following NAT command sets should be applied on Router1's interface and IOS global configuration mode? (Choose two)
• Refer to the exhibit. What can be concluded about the router configurations as shown in the graphic? (Choose two)
• Refer to the diagram. Router "R1" is performing NAT. From the output of the command, which of the following is a valid inside global address after the router performs NAT?
• Which of the following NAT types **DOES NOT** allow mapping of a set of inside local addresses (pool) to share a single inside global address when communicating with the Internet?
• Which of the following are two advantages when using NAT? (Choose Two)
• What occurs as soon as the hosts on a private network try to access a remote network over the Internet using a Cisco router configured with PAT?
• What service lets a router use the same IP address with different TCP source port numbers for each link?
• What is the NAT term for addresses that are assigned to outside devices and not advertised to the inside devices?
• Refer to the diagram. Which command was executed to receive the following results?
• Refer to the exhibit below. Router _R1 is being configured with NAT. What type of interface is S1/0 in relation to the NAT configuration?